Information for Alliance Promotion chipset users Loïc Grenié (), Henrik Harmsen () 6 March 2000 1. Support chipsets The apm driver in the SVGA server is for Alliance Promotion graphics chipsets. The following chipsets are supported: o 6422 Old chipset. The driver is still very unstable and has computer crashes. You should use XFree86 3.3.x for this chipset. o AT24 As found in Diamond Stealth Video 2500. Quite similar to AT3D. o AT25, AT3D AT3D is found in Hercules Stingray 128/3D. Most other Voodoo Rush based cards use the AT25 which is identical except it doesn't have the 3D stuff in it. 2. Acceleration The apm driver uses the XAA (XFree86 Acceleration Architecture) in the SVGA server. It has support for the following acceleration: o Bitblts (rectangle copy operation) o Lines (solid, single pixel) o Filled rectangles o CPU->Screen image transfers. o CPU->Screen colour expansion (text accel). o Screen->Screen colour expansion (cached text accel). o Mono 8x8 pattern fill. Not for 6422. o Colour 8x8 pattern fill (in 8bpp). Not for 6422. o Hardware cursor. o Pixmap caching. All in 8, 16 and 32 bpp modes. In 24bpp mode only Bitblts and Filled rectan- gles is supported. Also VESA DPMS power save mode is fully supported with "standby", "suspend" and "off" modes (set with with the "xset dpms" command). 3. DGA Full DGA 2.0 support with framebuffer access and drawing acceleration. 4. Video It has limited hardware support for video decoding on the AT24 and AT25/3D. It can also display an image in YUV colours inside the desktop. There are some more exotic formats such as YUV 4.1.1, YUV 4.0.0 and RGB 8,16.32bpp. 5. Shadow framebuffer There is a mode, called shadow framebuffer, where the graphics are used to display the images. All rendering is done in memory in a so-called shadow framebuffer. This mode is useful if you need lots of reading in the video memory and to use it you will have to put Option "ShadowFB" in your XF86Config file. 6. Configuration First: Run the xf86config program to create a correct configuration. You can turn off hardware cursor by inserting the following line in the Device section of the XF86Config file: Option "SWcursor" Or turn off hardware acceleration: Option "noaccel" Or turn off MMIO Option "nolinear" Do not specify either the amount of video RAM or which chipset in the config file. It is better to let the driver probe for this. Also do not put any "clocks" line in the device section since these chips have a fully pro- grammable clock that can almost take any modeline you throw at it. It might though fail at some specific clock values but in that case you should just try a slightly different clock and it should work. 7. glide2x There is support for the XF86Rush extension for use with the glide2x library. 8. Questions Any questions regarding this driver should be sent to Loïc Grenié. It should be possible to add support for the 3210 chipset if someone needs it. Generated from XFree86: xc/programs/Xserver/hw/xfree86/doc/sgml/apm.sgml,v 1.6 dawes Exp $